
Main water line rebuild — copper repipe with Moen Flo shutoff
Tore out corroded galvanized main and rebuilt the service in clean type-L copper with a Moen Flo smart shutoff, new hose bib, and pressure-tested every joint.
A running log of jobs we've completed and ones we're actively on across Southwest Florida. Photos of recent work are being added regularly.

Tore out corroded galvanized main and rebuilt the service in clean type-L copper with a Moen Flo smart shutoff, new hose bib, and pressure-tested every joint.

The original setup: rusted galvanized main, aging gate valve, and mixed copper/PVC transitions before Sam replaced the whole assembly.

Rebuilt a leaking under-sink drain assembly with a fresh PVC P-trap, tightened supply connections, and set a leak-detection tray under the disposal for early warning on the next drip.

Cut back tired old shutoffs and soldered on new quarter-turn angle stops so the homeowner can service faucets and toilets without touching the main.

Set a double-bowl stainless sink, installed a brushed-nickel pull-down faucet, and wired in an InSinkErator disposal — all sealed, tested, and leak-free before we packed up.

Cleared a badly backed-up commercial restroom floor drain with the Milwaukee M18 drum machine, then flushed and sanitized the area before turning it back over to staff.

Swapped a failed unit for a new InSinkErator Badger, re-tied the dishwasher branch, and pressure-checked the trap for a quiet, drip-free finish.

Replaced a waterlogged bladder tank and re-plumbed the softener + carbon filter loop so the whole-house system holds pressure and cycles the way it should.

Set a modern brushed-nickel widespread faucet on a remodeled vanity — new supplies, new pop-up drain, and a clean silicone bead at the deck.

Replaced a corroded angle stop, tuned up the P-trap, and re-secured the drain arm so the pedestal sink drains fast and stays leak-free.

Pulled a leaking electric water heater out of a tight interior closet next to the air handler, capped the lines, and prepped the pan area for the new unit.

Set and hooked up a new Rheem Performance electric water heater with a fresh T&P valve, dielectric unions, and expansion tank — tested to full temp before we left.
Replaced aging polybutylene with a full PEX-B system, new manifold, and pressure-tested every fixture.
New shower valve, freestanding tub supply, double-vanity drains, and pressure-balanced fixtures.
Have a project in mind? Get a straight answer from a licensed plumber — call(239) 776-2919 or book online.